5115A Test Set
Accurate, Cost Effective Measurements in Seconds
The 5115A leverages the extensive knowledge and experience obtained by Symmetricom during the development of the industry standard for ADEV measurements, the 5110A. The next generation 5115A makes accurate single sideband (SSB) phase noise and ADEV measurements at the click of a button, all at a fraction of the cost of alternative solutions. With a frequency range of 1 – 30MHz, the next generation 5115A also provides phase noise measurement accuracy down to previously impossible levels of ±1.0 dB.
One Box Solution
The innovative 5115A combines sophisticated timing technologies into a single advanced instrument, which integrates all required measurement functionality into a one box solution, requiring no calibration or configuration.
Accurate Measurements Without An External Reference
Since all configuration and calibration is done by the 5115A, extremely accurate measurements are made without a highly trained engineer having to oversee these measurements. To begin making measurements simply connect the device under test and reference (which is optional with the 5120A-01) to the 5120A and press the green Start button. Within seconds results are presented on the high resolution, real-time display.
The National Institute of Standards and Technology (NIST) calibrated a sample 5115A and confirmed its accuracy to be better than ±1.0 dB, the best in the industry. Its ADEV specification is <1E-14 at 1 second averaging time.
Futureproofed Test Set
A quick factory upgrade converts the 5115A into a 5120A, improving the phase noise floor by up to 28 dB.
Wide Range Measurement Capability
The 5115A’s all-digital design supports the widest range of phase noise and ADEV measurements of any commercially available product. The patented all-digital design in the 5115A enables phase noise measurements, to be without carrier suppression, which allows measurements below 0.1 mHz. This same technology makes ADEV measurements to over 300 days possible.
No Longer Must the Reference and DUT be at the Same Frequency
Unlike traditional measurement systems, the 5115A does not require that the frequency of the reference be the same as the DUT, thus allowing accurate measurements to be made on a DUT at any frequency, with a single low noise reference.
Output Options for Further Analysis
The 5115A meets the needs of applications requiring printing or further data analysis. The front panel Print button allows direct printing. When further data analysis is required, measurement data from the 5115A can be easily imported into industry standard software for frequency stability analysis, like Stable32.